Extended Ejector Housing Screw for Ruger 8-36 tpi. I make these, CNC made with proper OD that fills the pocket and longer so they can be timed and fitted. They are machined out of Heat Treated 4140 and can be nitred blued or Hot Blued after fitting. Service can also be done as well. They extend past the top of the Ejector Rod Housing by .100"
The Winchester 1885 Takedown has been long regarded as a graceful and well executed design and has been a wonderful shooter and collectible rifle for over 100 years. Until now, replacement takedown latches or parts were impossible to find. I have manufactured replacements for both the High Wall and Low wall with the same thread pitch and dimensions as originals. They are CNC manufactured out of 4140 for the body, 4140 Heat Treated for the latch, friction screw, lock wedge and lock screw. The detent and spring are German manufactured. They can be purchased in three finishes. Complete rifle finishing, new barrel sets can also be done in house for those that want extra barrel sets. I can also take a non take down and manufacture it into a takedown.
These are made from O-1 Tool Steel or 17-4 Stainless Steel. Blued, Matte Finished or Polished. They are a replacement for the Hammer Lock on the Smith & Wesson revolvers and are easy to install using the factor spring and keeper.
